Two types of nanoparticles TiO₂ and SiO₂ treated with silane coupling agents were incorporated into phenyl silicone rubber at a low concentration (≤1.0%) and cured by the room temperature vulcanized method. The results showed that treated TiO₂ or SiO₂ nanoparticles improved the ultraviolet (UV)-shielding ability and enhanced the visible transmittance of the phenyl silicone rubber, compared with their respective untreated particles. Moreover, when comparing treated nanoparticles, TiO₂ was more responsible for augmenting the UV-shielding ability of the phenyl silicone rubber, while SiO₂ played a more important role in increasing the transmittance of visible light. Low levels of nanoparticles reduced the dielectric constant of the nanocomposite; however, on reaching a critical concentration, increasing the nanoparticle content had the opposite effect. The thermal conductivity of nanocomposites increased linearly with the amount of treated nanoparticles, while SiO₂ nanocomposites exhibited better thermal conductivity than those of TiO₂. © 2015 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2015, 132, 42806.

Rigid polyurethane foams (RPUFs) were prepared with specific heteroaromatic and brominated benzyl polyols. The mechanical properties and thermal stability were studied using dynamic mechanical analysis (DMA) and thermogravimetric analysis (TG). The limiting oxygen index (LOI) was used to investigate the flame retardancy of the RPUFs. The results showed that the glass transition temperature (T_g) of the RPUF prepared by heteroaromatic polyol was 182°C, demonstrating an improved thermal stability for this specific heteroaromatic polyol. Brominated benzyl polyol exhibited less negative influence on mechanical properties of the RPUFs at the same time of improving the flame retardancy. The LOI values increased with an increase in the brominated polyol content to 27.5%, and the char-forming ability of the RPUF improved; the char residue rate reached 12.6% at 700°C, but it was only 6.2% without the flame retardant. Scanning electron microscope (SEM) and energy-dispersive spectrometry (EDS) verified that the mechanism of flame retardancy was due to a synergistic effect of the gas phase and the condensed phase. © 2015 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2015, 132, 42349.